How to replace the selector (3)
Resolution
Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/
WARNING! RISK OF ELECTRIC SHOCK
Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.
WARNING! RISK OF INJURY
Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.
WARNING! RISK OF EYE INJURY
Wear safety glasses if you perform maintenance or repair work involving springs.
WARNING! RISK OF BURNS
Before any repair or maintenance operation make sure the appliance is not hot.
WARNING! CHOKING HAZARD
Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.
Only adults should use or install the product.
Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.
Do not use or install the product if damaged.
Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.
HOW TO REPLACE ROTARY SELECTOR, HOB CONTROL
Screw placement and their number may differ depending on appliance.
1. Unscrew the screws under the hob front panel.
2. Remove the hob front cover by pulling it forward (NOTE: If stiff use a flat bladed screwdriver wrapped in a cloth to protect the paint on the cover).
3. Unscrew the screw for the earth tag connected to the hob front panel. (NOTE: Ensure all earth connections are reconnected when reinstalling)
4. Pull the control knobs up to remove and then unscrew the screws holding the selector switches in place.
5. Carefully disconnect the wiring connector(s) from the rotary selector. NOTE: Take a photo before disconnecting the wiring to ensure correct reinstallation.
6. Transfer the gasket from the rotary selector to the new rotary selector.
7. When assembling, repeat steps in reverse order.