Tumble dryer displays error message E50
Resolution
Issue:
- Tumble dryer displays error message E50. It indicates a motor or software problem.
Applies to:
- Vented dryer
- Condenser dryer
- Heat pump dryer
Resolution:
1. Reset the appliance.
- Remove the plug from the socket, wait 30 seconds and then plug it in again (The same result may be achieved by using the safety switch).
- After plugging in the appliance, switch it on and select a program.
2. Contact an Authorized Service Center.
If the above suggestions did not solve the problem, we recommend requesting a visit by a service engineer.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Was this article helpful?
Related Articles
- Tumble dryer displays error message CD
- Warning light(s) of tumble dryer cannot be switched off
- Cleaning tumble dryer filters and condenser
- Heat pump dryer's drying cycle is too long
- What can water from a tumble dryer be used for?
- Tumble dryer's drying results are poor and laundry is damp after drying
- Tumble dryer does not start / does not work
- Tumble dryer displays error message E60 and does not heat up
- Clothes are still wet at the end of the drying cycle
- Condenser tumble dryer taking too long to finish
Related Articles
- Tumble dryer displays error message CD
- Warning light(s) of tumble dryer cannot be switched off
- Cleaning tumble dryer filters and condenser
- Heat pump dryer's drying cycle is too long
- What can water from a tumble dryer be used for?
- Tumble dryer's drying results are poor and laundry is damp after drying
- Tumble dryer does not start / does not work
- Tumble dryer displays error message E60 and does not heat up
- Clothes are still wet at the end of the drying cycle
- Condenser tumble dryer taking too long to finish