Washing machine displays error message EHO / EH0
Issue
- The washing machine displays one of the following error messages: EHO / EH0, EH1, EH2, EH3
Applies to
- washing machine
- washer dryer
- tumble dryer
Resolution
1. Check the power supply by plugging a different product into the same socket and see whether that works.
If the other product also does not work, the problem is probably with the wiring fault.
Warning: Never use an extension cable to connect appliances. This can cause a short-circuit or fire hazard.
Important: Contact your local electrician for advice and guidance on fixing wiring problems.
2. Reset the appliance.
- Remove the plug from the socket, wait 30 seconds and then plug it in again (The same result may be achieved by using the safety switch).
- After plugging in the appliance, switch it on and select a program.
Still need help? Get expert support
If the issue continues, a professional technician can help diagnose and fix the problem.
No matter if your appliance is in warranty, out of warranty, or covered by an appliance protection plan — we’ll guide you to the right service.
Cause
- EH0 - indicates a problem with the power supply
- EH1 - Frequency of power supply out of range
- EH2 - Supply voltage too high
- EH3 - Supply voltage too low
Was this article helpful?
Related Articles
- How to change the temperature in the ECO 40-60° program?
- How to clean the rubber seal on my AEG washing machine
- Washing Machine Error E10, E11 or C1? How to Fix Water Supply & Drain Issues
- Washing machine emits a burning smell
- Washing machine does not drain, displays error code E20, E21 or C2, emits 2 beeps / 2 flashes
- Washing machine stops in the middle of a cycle
- There is no half load button on my washing machine
- The door of the washing machine cannot be opened
- How to clean and maintain your AEG washing machine and extend its life
- How to set up AutoDose in the AEG washing machine? (super compact detergent) (video)
Spare parts & Accessories
Find original spare parts and accessories for your appliance in our webshop and have them delivered directly to your door.
Related Articles
- How to change the temperature in the ECO 40-60° program?
- How to clean the rubber seal on my AEG washing machine
- Washing Machine Error E10, E11 or C1? How to Fix Water Supply & Drain Issues
- Washing machine emits a burning smell
- Washing machine does not drain, displays error code E20, E21 or C2, emits 2 beeps / 2 flashes
- Washing machine stops in the middle of a cycle
- There is no half load button on my washing machine
- The door of the washing machine cannot be opened
- How to clean and maintain your AEG washing machine and extend its life
- How to set up AutoDose in the AEG washing machine? (super compact detergent) (video)