Washing machine - How to replace the conveyor (1)

Applies to

  • Washing machine

Resolution

Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/

WARNING! RISK OF ELECTRIC SHOCK

Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.

WARNING! RISK OF INJURY

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

WARNING! RISK OF EYE INJURY

Wear safety glasses if you perform maintenance or repair work involving springs.

WARNING! RISK OF PINCHING

Wear safety glovesif you perform maintenance or repair work involving belts.

WARNING! CHOKING HAZARD

Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.

Only adults should use or install the product.

Before any maintenance operation, turn off water supply to the appliance. Always empty the appliance of all the water. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.

Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.

Do not use or install the product if damaged.

Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.

HOW TO REPLACE CONVEYOR, DETERGENT DISPENSER


1. Open the detergent drawer and push the tab at the back left of the drawer to release the detergent drawer.


2. Unscrew the two 8mm screws on the back of the washing machine lid and slide back to release.



3. Unscrew the three 8mm screws on the water dispenser unit and the three 7mm screws at the top of the control panel.


4. Unscrew the two PH2 screws in the detergent drawer housing and the four Torx 20 screws on the cross bar.



5. Use a flat bladed screwdriver to release the clip holding the detergent dispenser to the control panel. Pull the control panel towards you to release the control panel.


6. Unclip the eight clips around the outside of the detergent dispenser and then lift conveyor to remove.


7. When assembling, repeat steps in reverse order.

Was this article helpful?

Spare parts & Accessories

Find original spare parts for your appliance in our webshop and have them delivered directly to your door.

To the webshop

Find your User Manual

Solve problems and find instructions and other documentation for your product.

Find manual

Book a repair

Need to arrange a repair technician visit? Repairs under warranty are free of charge and we are here to support you after your warranty has expired. Authorised Technicians and genuine parts for complete peace of mind.

Book service