Tumble dryer displays error message E80
Issue
- Tumble dryer displays error message E80. It indicates a problem with the cycle selector or the software
Applies to
- Condenser dryer
- Heat pump dryer
Resolution
1. Make sure the cycle selector is not set between two programme options.
2. Reset the appliance.
- Remove the plug from the socket, wait 30 seconds and then plug it in again (The same result may be achieved by using the safety switch).
- After plugging in the appliance, switch it on and select a program.
3. Contact an Authorized Service Center.
If the above suggestions did not solve the problem, we recommend requesting a visit by a service engineer.
Was this article helpful?
Related Articles
- How to dry a down jacket?
- The dryer's cycle is taking too long
- Tumble dryer ends the programme immediately after the start
- Condenser tumble dryer taking too long to finish
- Water leakage from under the dryer
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer’s water tank is empty
- How long does a full load dry to dry take in a dryer - heatpump vs condenser?
- Clothes are still wet at the end of the drying cycle
- How to change the dryer door opening directions?