Washer dryer displays error message E90, E91, E92, E93 or E94
Issue
- Washer dryer displays error message E90, E91, E92, E93 or E94.
Applies to
- washer dryers
Resolution
1. Reset the appliance.
Remove the plug from the socket, wait 30-60 seconds and then plug it in again.
2. Contact an Authorized Service Center.
If the above suggestion did not solve the problem, we recommend requesting a visit by a service engineer.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Get expert support
If the issue continues, a professional technician can help diagnose and fix the problem.
No matter if your appliance is in warranty, out of warranty, or covered by an appliance protection plan - we’ll guide you to the right service.
Cause
- Error code E90 indicates configuration / communication problems with the electronic parts.
Was this article helpful?
Related Articles
- How to clean and maintain your AEG washer dryer
- Drying cycle of washer dryer takes too long, too short or not drying at all
- LED flashes on the washer - dryer's display
- Fabric conditioner runs directly down into the washer-dryer’s drum
- Washer dryer displays error message E20 or C2, emits 2 beeps or 2 flashes
- Washer dryer displays error message EF0, EF3 or emits 15 beeps / 15 flashes
- Washer-dryer emits noises and shakes while spinning
- How to clean and maintain your AEG washer dryer and extend its life
- Clothes are too creased after washing in the washer dryer
- Washer dryer displays error message E10, C1 or emits 1 beep / 1 flash
Spare parts & Accessories
Find original spare parts and accessories for your appliance in our webshop and have them delivered directly to your door.
Related Articles
- How to clean and maintain your AEG washer dryer
- Drying cycle of washer dryer takes too long, too short or not drying at all
- LED flashes on the washer - dryer's display
- Fabric conditioner runs directly down into the washer-dryer’s drum
- Washer dryer displays error message E20 or C2, emits 2 beeps or 2 flashes
- Washer dryer displays error message EF0, EF3 or emits 15 beeps / 15 flashes
- Washer-dryer emits noises and shakes while spinning
- How to clean and maintain your AEG washer dryer and extend its life
- Clothes are too creased after washing in the washer dryer
- Washer dryer displays error message E10, C1 or emits 1 beep / 1 flash