Washing machine displays error message E90, E91, E92, E93 or E94
Resolution
Issue
- Washing machine displays error message E90, E91, E92, E93 or E94. It indicates configuration / communication problems with the electronic parts.
Applies to
- Front loader washing machine (integrated and freestanding)
- Top loader washing machine
Resolution
1. Reset the appliance.
Remove the plug from the socket, wait 30 seconds and then plug it in again.
2. Contact an Authorized Service Center.
If the above suggestion did not solve the problem, we recommend requesting a visit by a service engineer.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Was this article helpful?
Related Articles
- Connected appliances - The appliance cannot be registered
- How to stop your washing machine vibrating and reduce noise / unbalanced load / reduce vibration during rinse
- Washing machine displays "CLE" - drum cleaning reminder
- Washing machine displays error message E10, E11, C1 or emits 1 beep / 1 flash
- Washing machine’s fluff filter is jammed, cannot be removed
- Washing machine does not drain, displays error code E20, E21 or C2, emits 2 beeps / 2 flashes
- The door of the washing machine cannot be opened
- How to remove transit bolts from your AEG washing machine
- Washing machine stops in the middle of a cycle
- Connected appliances - problems with onboarding and Wi-Fi connection