Washing machine's door can be opened and water runs out onto the floor
Resolution
Issue:
- Washing machine's door can be opened and water runs out onto the floor
Applies to:
- Front loaded washing machine
Resolution:
1. Start a draining cycle before turning off the machine and opening the door, otherwise the water will run out onto the floor.
2. Contact an Authorized Service Center.
If the door can be opened with water in the machine and the above advices do not resolve the problem, we recommend requesting a visit by a service engineer.
Cause:
- If a wash cycle with a "Rinse Hold" was chosen and the machine was turned off by using the cycle selector or disconnecting it from the power, the door can be opened after a few minutes, even though there is water in the machine.
Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.
Was this article helpful?
Related Articles
- Washing machine displays error message E10, E11, C1 or emits 1 beep / 1 flash
- Seal on the washing machine's door is damaged
- How to stop your washing machine vibrating and reduce noise / unbalanced load / reduce vibration during rinse
- Washing machine displays error message EF0, EFo, EF3 or emits 15 beeps / 15 flashes
- How to clean and maintain your AEG washing machine and extend its life
- Can I connect my washing machine to a hot water supply?
- Washing machine displays an error code, how to fix it?
- Washing machine displays error message E50
- Washing machine does not take detergents / water remains in the fabric softener compartment
- Washing Machine Installation Guide