Condenser Dryer Drain Kit

Issue

• Condenser Dryer Drain Kit E2YH01
• How to connect tumble dryer directly to the drain or sink?

Applies to

• Tumble Dryers

Resolution

Condenser Dryer Drain Kit

This handy kit is designed to empty water from your condenser dryer, by draining it directly into a sink, U-bend or drain. You will no longer need to empty the water collection tank at the end of each cycle.

The kit includes:

• 2.5m of semi-transparent hose
• 1x nylon band
• 1x 90° fitting for connecting the drain hose
• 1x plastic curved part to be used for discharging in a sink
• 1x plastic anchoring support for fastening the drain hose to the back of the appliance
• 1x gasket

Please note: this kit is only suitable for models where the tank is located at the top of the appliance.

This discharging kit will allow your tumble dryer to discharge the condensation water produced during each drying cycle directly into the nearest drain, without your having to empty out the tank at the end of the cycle.

Important! The operation described below must be carried out before completing the stages of the entire installation of the tumble dryer.

Download dryer kit E2YH01 installation instruction

1. Open the door of your tumble dryer, and extract from the drum the bag that contains the following items of the discharging kit:

● a nylon band;(5)

● a 90° fitting for connecting the draining hose;(3)

● a plastic curved part to be used for discharging into a sink;(2)

● a plastic anchoring support for fastening the draining hose to the back of the machine;(4)

● 2,5 metres of semi-transparent hose;(1)

● a gasket.(6**)

2. Position the tumble dryer so its back is towards you.

At the top right you can see a red hose which comes out of the back and is fastened to a plastic fitting.

3. Using a pair of pliers, loosen the metal band and push it down, in order to be able to extract the red hose from the plastic fitting.

4. Take the 90° fitting that has been supplied and insert it into the red hose.

5. Insert the plastic anchoring support that fastens the draining hose to the back, then connect the other end of the draining hose to the 90° fitting.

6. Using the nylon band, fasten the red hose to the fixed fitting on the back.

6*, 7. By means of a 7-mm socket spanner, unscrew the screw shown in the figure from the back. Insert the screw you have removed into the relevant seat on the plastic anchoring support, and tighten the screw, positioning the draining hose as shown in the figure.

8. If necessary, shorten the draining hose. If you wish to discharge the condensation water into a sink, you will have to apply the plastic curved part to the draining hose, in order to be able to hang it on the edge of the sink.

9. Important! Do not hang the curved part at a height exceeding 1 metre, and suitably shorten the draining hose so as not to create a bend higher than 0.5 metres, as shown in the figure.