Easy Door Opening overlay - installation instructions
Resolution
Easy Door Opening
When the fridge or freezer is cooling, the door may be harder to open shortly after closing. This is normal and caused by internal air pressure. This additional part helps equalize the pressure and makes opening easier.
Overlay Installation Instructions
- Remove the protective liner from the back of the overlay.
- Place the overlay in the center of the bottom frame of the appliance.
- Make sure the surface is clean and dry before applying.
Important: Keep the overlay away from children – there is a risk of swallowing small parts.
How it works
The overlay helps balance the air pressure, so the door opens more easily. It does not affect cooling or sealing.
Was this article helpful?
Related Articles
- Water Pooling In Fridge Freezer Base / Bottom / Floor
- Temperature in the fridge-freezer is too low
- Serial number/Model number/Product number (PNC) on my fridge freezer
- Fridge Door Will Not Close
- Why Is My Fridge Compressor Running Continuously?
- Is the temperature inside the fridge freezer the same in every part?
- How to change the water filter in my fridge freezer ? (located on the back)
- Fridge freezer shows an alarm, red warning light, flashing triangle or beeps
- Strange noises from Fridge Freezer
- How to use “power cool”, and “power freeze” function?
Spare parts & Accessories
Find original spare parts and accessories for your appliance in our webshop and have them delivered directly to your door.
Related Articles
- Water Pooling In Fridge Freezer Base / Bottom / Floor
- Temperature in the fridge-freezer is too low
- Serial number/Model number/Product number (PNC) on my fridge freezer
- Fridge Door Will Not Close
- Why Is My Fridge Compressor Running Continuously?
- Is the temperature inside the fridge freezer the same in every part?
- How to change the water filter in my fridge freezer ? (located on the back)
- Fridge freezer shows an alarm, red warning light, flashing triangle or beeps
- Strange noises from Fridge Freezer
- How to use “power cool”, and “power freeze” function?