How to replace the control panel (2)
Issue
How to replace the control panel
Applies to
- Tumble Dryers
Resolution
Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/
WARNING! RISK OF ELECTRIC SHOCK
Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.
WARNING! RISK OF INJURY
Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.
WARNING! RISK OF EYE INJURY
Wear safety glasses if you perform maintenance or repair work involving springs.
WARNING! RISK OF PINCHING
Wear safety glovesif you perform maintenance or repair work involving belts.
WARNING! CHOKING HAZARD
Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.
Only adults should use or install the product.
Always empty the appliance of all the water, e.g. tumble dryer water container. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.
Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.
Do not use or install the product if damaged.
Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.
How to replace the control panel
1. Pull out and empty the condenser drawer.
2. Unscrew the three PH2 screws (two on the top and one underneath) to release the drawer front
3. Unscrew the two 8mm screws on the back of the washing machine lid and slide back to release.
4. Loosen the front fixing screw
5. Loosen the three screws securing the control panel to the uprights and air conduit
6. Loosen the 2 screws that secure the control panel to the tank support.
7. Remove the wiring, making a note of the position of the various connectors. Remove the entire control panel.
8. Using a small cross-head screwdriver, loosen the screws (shown by the arrows) securing the control panel to the front panel.
9. Release the hooks that secure the control panel to the front panel, which are situated beside the screw seats (take care not to break the hooks).
