Integrated built-in dishwasher door stuck closed
Issue
- Integrated built-in dishwasher door stuck closed
Applies to
- Integrated dishwashers
Resolution
- Check the appliance is not still performing a cycle
- Make sure the dishwasher is correctly levelled, try adjusting the appliance feet and checking with a spirit level.
- Contact the engineer who installed the appliance to ensure the latch and door have been installed in accordance with the instruction manual. If you are having issues the appliance may have been installed incorrectly - contact your installer to check if the door requires adjustment.
- Reset the appliance, switch off the power to the appliance then switch it back on again after 20 - 30 seconds. Test if the appliance is working
- You may require a visit by a service engineer
Cause
- Misalignment of latches and or hinges can cause the dishwasher door not to open and close properly and become crooked
Was this article helpful?
Related Articles
- Dishwasher displays error code i23, not draining
- Dishwasher does not beep at the end of the cycle
- Symbols & programmes on your AEG dishwasher
- Dishwasher is not heating up water
- Dishwasher Leaking – Causes and Solutions
- Too much foam in the dishwasher during or after finish of the cycle
- Dishwasher displays error code i30
- Dishwasher emits clicking/ticking noise during cycle
- Dishwasher displays error code i28, not draining
- How to deactivate/turn off AirDry/door opens automatically on AEG dishwasher
Related Articles
- Dishwasher displays error code i23, not draining
- Dishwasher does not beep at the end of the cycle
- Symbols & programmes on your AEG dishwasher
- Dishwasher is not heating up water
- Dishwasher Leaking – Causes and Solutions
- Too much foam in the dishwasher during or after finish of the cycle
- Dishwasher displays error code i30
- Dishwasher emits clicking/ticking noise during cycle
- Dishwasher displays error code i28, not draining
- How to deactivate/turn off AirDry/door opens automatically on AEG dishwasher