Tumble dryer does not switch on after a drying cycle
Resolution
Issue:
- Tumble dryer does not switch on after a drying cycle. It indicates a technical problem with the appliance.
Applies to:
- Vented dryer
- Condenser dryer
- Heat pump dryer
Resolution:
1. Contact an Authorized Service Center.
We recommend requesting a visit by a service engineer.
Make a note of the reported error code and quote it when you request an engineer. This will not solve your problem, but it will help our engineer identify the cause of the problem.
Was this article helpful?
Related Articles
- Heat pump tumble dryer clothes do not seem hot enough and taking too long to finish (video)
- Keep your outdoor garments waterproof
- How to clean and maintain your AEG tumble dryer to prolong its life
- Before using your AEG tumble dryer for the first time
- How to change the dryer door opening directions?
- Drying Temperature in Heat Pump Tumble Dryer
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Clothes are still wet at the end of the drying cycle
- Start - Pause LED flashes on tumble dryer
- Tumble dryer displays error message E60 and does not heat up
Related Articles
- Heat pump tumble dryer clothes do not seem hot enough and taking too long to finish (video)
- Keep your outdoor garments waterproof
- How to clean and maintain your AEG tumble dryer to prolong its life
- Before using your AEG tumble dryer for the first time
- How to change the dryer door opening directions?
- Drying Temperature in Heat Pump Tumble Dryer
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Clothes are still wet at the end of the drying cycle
- Start - Pause LED flashes on tumble dryer
- Tumble dryer displays error message E60 and does not heat up