Tumble dryer - How to replace heating element (2)

Applies to

  • Tumble Dryers

Resolution

missing alt text

Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/

missing alt text

WARNING! RISK OF ELECTRIC SHOCK

Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.

missing alt textmissing alt text

WARNING! RISK OF INJURY

missing alt text

Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.

missing alt text

WARNING! RISK OF EYE INJURY

missing alt text

Wear safety glasses if you perform maintenance or repair work involving springs.

missing alt text

WARNING! RISK OF PINCHING

missing alt text

Wear safety glovesif you perform maintenance or repair work involving belts.

missing alt text

WARNING! CHOKING HAZARD

Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.

Only adults should use or install the product.

Always empty the appliance of all the water, e.g. tumble dryer water container. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.

Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.

Do not use or install the product if damaged.

Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.

HOW TO REPLACE HEATING ELEMENT

1. Unscrew the two PH2 screws on the back top of the appliance and slide the slide back to release.

missing alt textmissing alt text

2. Unscrew the three 7mm screws for the heat shield and remove the heat shield by pulling from the top towards you.

missing alt textmissing alt text

3. Unscrew the seven 7mm screws around the edge of the heating element cover to release.

missing alt text

4. Carefully disconnect wiring connectors from the heating element. (Note: Take a photo of the wiring positioning/location before disconnecting) Be careful not to damage the connectors.

missing alt text

5. Carefully release the cable holder from the back panel and the cable from the internal holder to release the heating element cable.

missing alt textmissing alt textmissing alt text

6. Unscrew the 7mm screw on the right-hand side of the heating element, then pull from the right-hand side of the element to release the tab on the left of the element.

missing alt textmissing alt text

7. Use a small flat blade screwdriver to release the cable tie clip and refit to the new element

missing alt text

8. When assembling repeat stepsin reverse order.

Was this article helpful?

Spare parts & Accessories

Find original spare parts for your appliance in our webshop and have them delivered directly to your door.

To the webshop

Find your User Manual

Solve problems and find instructions and other documentation for your product.

Find manual

Book a repair

Need to arrange a repair technician visit? Repairs under warranty are free of charge and we are here to support you after your warranty has expired. Authorised Technicians and genuine parts for complete peace of mind.

Book service