Tumble Dryer - How to replace the bush roller
Issue
How to replace the bush roller
Applies to
- Tumble Dryers
Resolution
Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/
WARNING! RISK OF ELECTRIC SHOCK
Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.
WARNING! RISK OF INJURY
Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.
WARNING! RISK OF EYE INJURY
Wear safety glasses if you perform maintenance or repair work involving springs.
WARNING! RISK OF PINCHING
Wear safety glovesif you perform maintenance or repair work involving belts.
WARNING! CHOKING HAZARD
Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.
Only adults should use or install the product.
Before any maintenance operation, turn off water supply to the appliance. Always empty the appliance of all the water. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.
Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.
Do not use or install the product if damaged.
Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.
HOW TO REPLACE BUSH ROLLER
1. Unscrew the Torx 20 screw in the condenser drawer housing. Then unscrew the two Torx 20 screws on the back of the appliance lid and slide back to release.
2. Unscrew the eight Torx 20 screws on the back of the appliance side panels and the four Torx 20 screws on the top of the side panels.
3. To remove the side panels pull the panels up and away from the body of the machine to release the panels from the securing tabs at the bottom and on the side.
4. NOTE: When reinstalling slot the side panel into the three bottom tabs and the three side tabs to ensure the panels are flush with the body of the appliance.
5. Identify the roller that needs to be replaced on either side of the drum.
6. Unscrew the 8mm bolt through the middle of the roller.
7. Pull the roller off the roller spindle.
8. NOTE: During reinstallation you may have to lift the drum slightly to push the roller back onto the spindle.
9. Using pliers, pull the roller bushing to release from the basement housing.
10. When assembling, repeat steps in reverse order.