Tumble Dryer - How to replace the microswitch float
Applies to
- Washing machine
Resolution
Refer always to your product’s user manual safety information before any repair or maintenance operation. https://www.electrolux.com/support/user-manuals/
WARNING! RISK OF ELECTRIC SHOCK
Before any repair or maintenance operation, deactivate the appliance and disconnect the mains plug from the socket.
WARNING! RISK OF INJURY
Always take care when moving appliances. For heavy appliances it's safest for two persons to move it. Always use safety gloves and safety footwear. Wear safety gloves at all times to protect from cuts from sharp edges.
WARNING! RISK OF EYE INJURY
Wear safety glasses if you perform maintenance or repair work involving springs.
WARNING! RISK OF PINCHING
Wear safety glovesif you perform maintenance or repair work involving belts.
WARNING! CHOKING HAZARD
Small parts not for children under 3 years. Keep all small parts and packaging out of reach of children.
Only adults should use or install the product.
Before any maintenance operation, turn off water supply to the appliance. Always empty the appliance of all the water. Any maintenance should be carried out with the appliance standing upright. Residual water could damage electronics if the appliance is placed on any of its sides.
Make sure to use the product only for its designated purpose and verify that it is a compatible part for the intended product.
Do not use or install the product if damaged.
Please note that self-repair or nonprofessional repair can have safety consequences if not done properly and might void the warranty. Possessing the necessary know-how is essential.
HOW TO REPLACE MICROSWITCH FLOAT
1. Unscrew the Torx 20 screw in the condenser drawer housing. Then unscrew the two Torx 20 screws on the back of the appliance lid and slide back to release.
2. Unscrew the four Torx 20 screws on the back of the left appliance side panel and the two Torx 20 screws on the top of the left side panel.
3. To remove the side panel pull the panel up and away from the body of the machine to release the panel from the securing tabs at the bottom and on the side.
4. NOTE: When reinstalling slot the side panel into the three bottom tabs and the three side tabs to ensure the panel is flush with the body of the appliance.
5. Unscrew the 7mm screw holding the pump/microswitch cover in place and lift to remove.
6. Release the wiring from its support and then unclip the wiring connector from the microswitch float. Be careful not to damage the wiring connector.
7. Unclip the two clips holding the microswitch in position and then lift to release. (NOTE: Take a photo before removal to ensure you position the microswitch float correctly during reinstallation).
8. When assembling, repeat steps in reverse order.