When I open my AEG tumble dryer, there is a large amount of lint / fluff (video)
Resolution
Issue:
- When I open my tumble dryer, there is a large amount of lint / fluff
Applies to:
- Vented dryer
- Condenser dryer
- Heat pump dryer
Resolution:
1. Check the air circulation while cleaning.
2. Clean the filters in the door opening.
3. In case of the condenser or heat pump tumble dryer also clean the condenser / heat exchanger, located at the bottom of your appliance.
4. In case of the vented tumble dryer, check if there is unrestricted air flow through the vent hose and through any wall.
5. Contact an Authorized Service Center.
If the above suggestions did not solve the problem, we recommend requesting a visit by a service engineer.
Cause:
- It is normal that lint forms during the drying process and it cannot be avoided. This process is very dependent on the load (e.g. new towels, fleece etc.).
How to change the fluff filter of your tumble dryer:
Was this article helpful?
Related Articles
- Tumble dryer emits a louder noise during wool cycle
- Cleaning tumble dryer filters and condenser
- Tumble dryer does not start / does not work
- Clothes are still wet at the end of the drying cycle
- Tumble dryer displays error message CD
- Tumble dryer has no power
- Tumble dryer displays a padlock
- Condenser Dryer Drain Kit
- Tumble dryer displays error message EHO, EH0
- The dryer's cycle is taking too long
Related Articles
- Tumble dryer emits a louder noise during wool cycle
- Cleaning tumble dryer filters and condenser
- Tumble dryer does not start / does not work
- Clothes are still wet at the end of the drying cycle
- Tumble dryer displays error message CD
- Tumble dryer has no power
- Tumble dryer displays a padlock
- Condenser Dryer Drain Kit
- Tumble dryer displays error message EHO, EH0
- The dryer's cycle is taking too long