When switched the gas hob OFF and ON the message F appears, burners cannot be ignited
Issue
- Gas hob displays message H and those burners cannot be ignited
- When switched the hob OFF and ON the message F appears
Applies to
- Electronic Gas hobs
Resolution
1. Deactivate and activate the hob.
- After light animation, when "F" reappears, touch "||" and then within 3 seconds.
- When you see "0" the fault is reset
2. Make sure that the crown and the flame cap are correctly positioned, and clean the metal part of the flame safety device.
3. Contact an Authorized Service Center.
If the above advice does not resolve the problem, we recommend requesting a visit by a service engineer.
Was this article helpful?
Related Articles
- AEG extractor hob care guide: Do's and Don’ts
- AEG induction hob care guide: Do's and Don’ts
- Hob displays message L, the hob is locked
- How to use the child lock and lock function on your AEG induction hob
- Induction Hob Installation Faults: Error Codes, Causes & Support
- The cooking zone does not heat
- The outer circle of the cooking zone does not work
- What Cookware Works on Induction (Complete Guide)
- Induction hob displays error code F or F1
- How to use the FlexiBridge function on your AEG induction hob
Spare parts & Accessories
Find original spare parts and accessories for your appliance in our webshop and have them delivered directly to your door.
Related Articles
- AEG extractor hob care guide: Do's and Don’ts
- AEG induction hob care guide: Do's and Don’ts
- Hob displays message L, the hob is locked
- How to use the child lock and lock function on your AEG induction hob
- Induction Hob Installation Faults: Error Codes, Causes & Support
- The cooking zone does not heat
- The outer circle of the cooking zone does not work
- What Cookware Works on Induction (Complete Guide)
- Induction hob displays error code F or F1
- How to use the FlexiBridge function on your AEG induction hob