AEG 8000 Wet & Dry vacuum cleaner setup and maintenance

Issue

AEG 8000 Wet & Dry vacuum cleaner setup and maintenance

Applies to

• AEG 8000 Wet & Dry vacuum cleaner

Resolution

The AEG 8000 Wet & Dry Vacuum Cleaner is a versatile and powerful tool designed to handle both wet and dry cleaning tasks. This guide will walk you through the setup process and provide essential maintenance tips to ensure your vacuum cleaner operates efficiently for years to come.

How to set up your new AEG 8000 vacuum cleaner

1. Insert the battery, then attach the hand unit, body, and nozzle.

2. Plug the cable into the docking station, then connect it to a power source.

3. Store accessories on the docking station.

How to use Wet&Dry cleaning

1. Remove the water tank from the nozzle and open the lid.

2. Fill with water with a maximum temperature of 40°C.

3. To start using, turn on and the cleaner intuitively dispenses water.

4. For spot cleaning, press to release water manually.

5. Choose between Auto and High mode when you're mopping or Boost mode when dry vacuuming

6. When the power bar turns red, the machine is detecting dirty floor and when it turns blue, the floor is clean.

How to activate the Self-cleaning & Auto-drying function

1. To activate the Self-cleaning function, press the button when the unit is in charging

2. There are totally 2 minutes of water spraying and 5 minutes of floor brush cleaning.

3. To activate Auto-drying, press the speed adjustment button, and the power button.

4. If the battery percentage is lower than 20%, the drying mode is not available.

5. The whole process has a total of 60 cycles, each cycle lasts 3 minutes.

How to use the floor nozzle for powerful dry vacuuming

1. The cleaner can dry vacuum even with the main nozzle.

But for optimal performance, use the Multi-surface nozzle.

How to clean the dirty water tank

1. Remove the water tank from the body and use the cleaning brush to reach the crevices of the cleaner.

2. Disassemble the tank and rinse under water with a maximum temperature of 40°C to remove dirt and debris.

How to clean the brush rolls

1. Remove the clean water tank and detach the main tube from the nozzle base. Carefully rotate the levers outwards and slide out the brush rolls.

2. Rinse under water with a maximum temperature of 40°C to remove dirt and debris. Let them dry for at least 24 hours before reassembling.

How to clean the Multi-surface nozzle

1. Press the release button located on the side of the cleaner. Gently pull out the internal roller brush.

2. Cut away tangled hair or debris.

How to clean the filter and the dust bin

1 . Detach the dustbin from the hand unit.

2. Separate the filters and twist and detach the cyclone unit.

3. Rinse the parts under water with a maximum temperature of 40°C. Let them dry for at least 24 hours before reassembling.

4. Replace the filters every 12 months to maintain optimal performance.