Connected Oven displays error code F601 or F604
Issue
- Oven displays error code F601 or F604
Applies to
- Integrated Oven
Resolution
If your oven displays error message F601 or F604, refer to the suggestions below:
DISPLAY CODE | DESCRIPTION | TROUBLESHOOTING |
F601 | there is a problem with WiFi signal. | Check your network connection. Refer to the user manual, "Before first use" chapter, Wireless connection. |
F604 | the first connection to WiFi failed. | Turn the oven off and on and try again. |
1. Reset the appliance's WiFi settings and run onboarding again. for help with this.
2. Move your WiFi router closer to the appliance.
3. Contact your WiFi service provider to ensure a connection is available.
4. Make sure the WiFi signal is not disrupted by a microwave.
When one of these error messages continues to appear on the display it means there may be a faulty subsystem that has been disabled.
If all steps above have been followed and your appliance is still not connecting, please click on the 'Book A Repair' link on the right hand side of this page to arrange a service call.
Was this article helpful?
Related Articles
- How to remove oven shelf supports for cleaning
- The time is not shown on the display when the oven is turned off
- Oven cooling fan runs all the time
- Poor baking / roasting results
- After a short power failure, Demo appears on the display and my oven will not heat up - AEG
- How to set an oven clock
- Oven baking trays / roasting tins become warped
- How to set most AEG oven duration timers, end timer and up timer
- How to prove the dough in the oven, if it is not equipped with special programme?
- Symbols and functions on your AEG oven or cooker