Dishwasher displays error code iC0 / iCo
Appliance Issue
- Dishwasher displays error message iC0, iCo, iC1, iC2 or iC3
- My dishwasher is not working
Applies to
- Integrated dishwasher
- Freestanding dishwasher
Resolution
Reset your appliance:
- Remove the plug for the dishwasher
- Check your dishwasher filter and sump (see below) for signs of foam/suds & debris
- Make sure you clean all the filters
- Clean any foam/suds from the sump
- Plug it back in. Turn on the dishwasher, select a suitable cycle and start it.
- If the cycle starts and operates normally, the problem has been resolved.
If the above steps don't resolve the issue then a service visit by one of our approved service providers is recommended.
Cause
- iC0 code family indicates a technical malfunction of the appliance
Was this article helpful?
Related Articles
- Dishwasher salt consumption is too high
- The auto-cleaning indicator ("Machine Care") lights up on the dishwasher
- Dishwasher does not switch on, does not start a cycle, does not automatically open the door at the end of a cycle
- Dishwasher does not / will not start but the power is on
- Dishwasher Half-load function does not work
- Dishwasher displays error code i30
- Dishwasher not cleaning properly
- Before using your AEG dishwasher for the first time
- Dishwasher displays error code i10, i11, AL5, C1, beeps once, or the warning light flashes once
- How to adjust water hardness level in dishwasher