Dishwasher door will not close properly or is crooked
Resolution
Issue:
- Dishwasher door will not close properly or is crooked
Applies to:
- Integrated dishwasher
Resolution:
1. Make sure the appliance is correctly levelled
Try adjusting the appliance feet and checking it again with a spirit level
2. Contact the engineer who installed the appliance to ensure that the latch and door have been installed in accordance with the installation manual.
Misalignment of latches and/or hinges can cause the dishwasher door to not close properly or be crooked
3. Contact an Authorized Service Center.
If the above advice does not resolve the problem, we recommend requesting a visit by a service engineer.
Cause:
- Misalignment of latches and/or hinges can cause the dishwasher door to not close properly or be crooked
Was this article helpful?
Related Articles
- Symbols & programmes on your AEG dishwasher
- Dishwasher does not switch on, does not start a cycle, does not automatically open the door at the end of a cycle
- Dishwasher displays error code i23, not draining
- Dishwasher does not beep at the end of the cycle
- Dishwasher is not heating up water
- Dishwasher Leaking – Causes and Solutions
- Too much foam in the dishwasher during or after finish of the cycle
- Dishwasher displays error code i30
- Dishwasher emits clicking/ticking noise during cycle
- Dishwasher displays error code i28, not draining
Related Articles
- Symbols & programmes on your AEG dishwasher
- Dishwasher does not switch on, does not start a cycle, does not automatically open the door at the end of a cycle
- Dishwasher displays error code i23, not draining
- Dishwasher does not beep at the end of the cycle
- Dishwasher is not heating up water
- Dishwasher Leaking – Causes and Solutions
- Too much foam in the dishwasher during or after finish of the cycle
- Dishwasher displays error code i30
- Dishwasher emits clicking/ticking noise during cycle
- Dishwasher displays error code i28, not draining