Hob Displays Error Code E0, E1, E011, E012 or E013

Issue

If your hob displays error code E0, E1, E011, E012, or E013, if cooking zones cannot be used, or if the hob stops operating unexpectedly, the issue is typically related to the electronic control system.

Typical signs include:

• Error code E0 displayed on the hob
• Error code E1 displayed on the hob
• E011, E012, or E013 appears on the display
• Cooking zones do not respond

Applies to

• Induction hobs
• Ceramic hobs

Resolution

Start by checking the most common causes of the problem. In many cases, the issue can be resolved without service.

1. Disconnect the hob from the power supply at the wall socket or circuit breaker.
2. Wait approximately 1 minute.
3. Reconnect the power supply.
4. Check whether the error message has cleared and whether the hob operates normally.

In the case of built-in appliances, it is not necessary to physically disconnect the cable - the appliance can be disconnected using the household RCD breaker.

Important

If the error code reappears immediately after restoring power, further diagnosis or repair may be required.

Still need help? Get expert support

If the issue continues, a professional technician can help diagnose and fix the problem.

No matter if your appliance is in warranty, out of warranty, or covered by an appliance protection plan - we’ll guide you to the right service.

Book a repair online

Cause

These error codes indicate that the hob has detected a problem within the electronic control system.

The most common causes are:

• Temporary electronic communication errors
• Power supply disturbances
• Internal control board faults
• Component failures within the electronics

FAQ – Hob Error Codes E0 and E1

What does error code E0 mean on a hob?

E0 usually indicates that the hob has detected an electronic control system fault.

What does error code E1 mean on a hob?

E1 generally indicates a problem detected by the electronic monitoring system.

Can I continue using the hob when E0 or E1 is displayed?

No. The hob should be reset and checked before further use.

Will disconnecting the power remove the error code?

A power reset may clear temporary electronic faults and restore normal operation.

Is this error code always caused by a faulty component?

No. In some cases, the code may be triggered by a temporary power or communication issue.

When should I arrange a repair?

If the error code remains after resetting the hob or returns repeatedly, professional service is recommended.