Hood turns on by itself
Resolution
Issue:
- Hood turns on by itself
Applies to:
- cooker hood
Resolution:
1. If the hood turns on by itself, the possible cause is an error in communication between the primary electronic printed circuit board and the control electronics.
- Unplug the hood from the socket.
- Wait 30 seconds, then plug it back in.
- Alternatively, find the power switch and follow the same procedure.
2. Check if there is a problem with the remote control, if applicable.
- Replace the batteries if necessary.
- If the problem persists, remove the batteries and replace the remote control.
- Check for interference caused by nearby wireless devices or strong light sources, eg cordless phones or direct sunlight through window
3. You can find all necessary accessories in our Webshop.
4. If this doesn't resolve the issue, contact Authorized Service Center.
Was this article helpful?
Related Articles
- How to use the AEG Hob²Hood® function
- Cleaning the external surface of the cooker hood
- The Hob2Hood function does not work with the cooker hood
- Hood displays error message C or F
- Symbols and functions on your AEG cooker hood
- What is the adaptor I need to connect rectangular to circular ducting on a ceiling hood or Extractor Hob for example? M2CKCF02
- How to clean the filters on your AEG cooker hood
- Downdraft Extractor will not Retract - Stays Up
- Cooker hood stops during use
- The cooker hood is dripping water
Related Articles
- How to use the AEG Hob²Hood® function
- Cleaning the external surface of the cooker hood
- The Hob2Hood function does not work with the cooker hood
- Hood displays error message C or F
- Symbols and functions on your AEG cooker hood
- What is the adaptor I need to connect rectangular to circular ducting on a ceiling hood or Extractor Hob for example? M2CKCF02
- How to clean the filters on your AEG cooker hood
- Downdraft Extractor will not Retract - Stays Up
- Cooker hood stops during use
- The cooker hood is dripping water