Small marks on washing machine or tumble dryer glass door
Resolution
Issue:
- Small marks on washing machine or tumble dryer glass door
Applies to:
- washing machine
- tumble dryer
Resolution:
1. A small mark in the middle of the outer safety glass is not a malfunction of the machine.
- The mark is the casting point where the plastic is injected into the mold when the glass is produced.
- The outer plastic glass is a safety glass used to prevent burning your fingers when the washing machine washes with hot water, or the tumble dryer dries at high temperatures.
- The mark does not affect the machine’s function or life.
Was this article helpful?
Related Articles
- Washing machine displays error message E10, E11, C1 or emits 1 beep / 1 flash
- How to remove transit bolts from your AEG washing machine
- Washing machine does not work / does not react
- The door of the washing machine cannot be opened
- Fabric conditioner runs directly down into the washing machine's drum
- Washing machine blows fuses / trips RCD circuit breaker
- Can the washing machine's door be reversed?
- Fabric conditioner does not dissolve in my washing machine
- Washing machine does not drain, displays error code E20, E21 or C2, emits 2 beeps / 2 flashes
- Opening washing machine's door at the beginning of wash cycle