ULTIMATE 8000 Wet&Dry cordless vacuum cleaner - “TURBO” flashes on the display
Issue
- “TURBO” flashes on the display
Applies to
- ULTIMATE 8000 Wet&Dry cordless vacuum cleaner
- models: AW81U3DB, EW81U3DB
Resolution
Possible reason | Solutions |
Suction mode is activated by pressing “+/-“ button for one second. (Refer to the graphic on the center-right side of UI(display) introduction page) | Press the “+/-“ button again to exit the Suction mode. |
Was this article helpful?
Related Articles
- 8000 cordless vacuum cleaner - filter lamp lights up all the time
- AEG 6000 Cordless Cleaner - charging problem, low running time
- AEG 8000 vacuum cleaner - nozzle problems
- Cordless vacuum cleaner maintenance (AEG Clean 6000 / Hygienic 6000 / Animal 6000 series)
- Stick vacuum cleaner has reduced or no suction power
- Stick vacuum cleaner stops or does not start
- AEG 8000 Wet & Dry vacuum cleaner setup and maintenance
- ULTIMATE 8000 Wet&Dry cordless vacuum cleaner - “Dirty Water Tank Full” icon blinks
- ULTIMATE 8000 Wet&Dry cordless vacuum cleaner - self-cleaning does not start
- ULTIMATE 8000 Wet&Dry cordless vacuum cleaner - The suction is weakened