Water or other liquids has been sucked into the stick vacuum cleaner
Issue
- Water or other liquids has been sucked into the stick vacuum cleaner
Applies to
- stick vacuum cleaners
Resolution
1. Stop the product and let it dry for 48h.
Do not put it in the charging stand!
2. If the product is not working anymore it will be necessary to replace the motor at an authorized AEG service center.
Note: Damage to the motor caused by the penetration of water is not covered by the warranty.
Was this article helpful?
Related Articles
- AEG cordless vacuum cleaner care guide: Do's and Don’ts
- Battery replacement in cordless vacuum cleaners
- Stick vacuum cleaner has reduced or no suction power
- Stick vacuum cleaner does not charge the batteries
- 8000 series vacuum cleaner - control panel icons
- ULTIMATE 8000 Wet&Dry cordless vacuum cleaner - charging problems
- ULTIMATE 8000 Wet&Dry cordless vacuum cleaner - “Dirty Water Tank Full” icon blinks
- Cordless vacuum cleaner maintenance (AEG Clean 6000 / Hygienic 6000 / Animal 6000 series)
- My Cordless Ergorapido vacuum cleaner stops after a short time, lights flashing
- Stick vacuum cleaner stops or does not start
Related Articles
- AEG cordless vacuum cleaner care guide: Do's and Don’ts
- Battery replacement in cordless vacuum cleaners
- Stick vacuum cleaner has reduced or no suction power
- Stick vacuum cleaner does not charge the batteries
- 8000 series vacuum cleaner - control panel icons
- ULTIMATE 8000 Wet&Dry cordless vacuum cleaner - charging problems
- ULTIMATE 8000 Wet&Dry cordless vacuum cleaner - “Dirty Water Tank Full” icon blinks
- Cordless vacuum cleaner maintenance (AEG Clean 6000 / Hygienic 6000 / Animal 6000 series)
- My Cordless Ergorapido vacuum cleaner stops after a short time, lights flashing
- Stick vacuum cleaner stops or does not start