After a short power failure, Demo appears on the display and my oven will not heat up - AEG

Issue

• After power failure or after the fuse has been taken out, the display shows Demo without setting the demo mode manually.
• The heating setting, the temperature setting or other settings can be set, but the oven does not heat up.

Applies to

• Built-In Ovens
• Compact Ovens
• Double ovens

Resolution

Please ensure you are following the correct instructions for your oven display

PLEASE NOTE: If your oven is asking for a code with a “B C A” this means the Child Lock is on. Enter the code “A B C” to unlock. For more info on child lock settings click here

Ovens with command wheel

To deactivate the demo mode for command wheel models:

1. Switch on the device and select Menu with the command wheel.

2. Press the command wheel to confirm your selection.

3. Rotate the command wheel to find and select Basic Settings (last menu item).

4. Confirm by pressing the command wheel.

5. Rotate the command wheel to Service (last menu item).

Confirm again.

6. Select the first option "Demo Mode on".

Confirm again.

7. To deactivate the demo mode, enter the number sequence "2 4 6 8" using the command wheel to scroll and select.

Ovens with a touchscreen interface

To deactivate demo mode for touchscreen models

1 . Use up and down arrows to navigate to BASIC SETTINGS and press OK

2. Select “demo mode” and press OK

3. Select “off” and enter code “2 4 6 8” using the up and down arrows

4. Press OK to confirm

Ovens with retractable dials

To deactivate the demo mode for rotary dial models:

1. Turn off the oven

2. Press and hold the following 3 buttons simultaneously:

3. The word ‘Demo’ and number ‘1’ will flash

4. Enter the code 2 4 6 8 by turning the temperature knob to the right or left to change the values ​​and press clock symbol to confirm: the next digit will begin to flash.

5. "DEMO" mode is deactivated when you confirm the last digit and if the code is correct.