PF error code is displayed on the dishwasher's display
Issue
- Dishwasher shows error code PF on the panel
Applies to
- Freestanding dishwasher
- Built-in dishwasher
Resolution
- PF (Power Failure) code indicates low operating voltage
- The electrical supply voltage is out of range and might indicate a fault in your electrical installation. The washing program is temporarily stopped. As the electrical voltage improves, the machine continues to operate automatically.
- To avoid damage to the machine, we recommend leaving the dishwasher switched off until the voltage is OK, and not using the appliance.
- Book a repair
If the above did not solve the problem, we recommend booking a repair.
Was this article helpful?
Related Articles
- The auto-cleaning indicator ("Machine Care") lights up on the dishwasher
- Symbols & programmes on your AEG dishwasher
- Dishwasher does not switch on, does not start a cycle, does not automatically open the door at the end of a cycle
- Dishwasher displays error code i23, not draining
- Dishwasher does not beep at the end of the cycle
- Dishwasher is not heating up water
- Dishwasher Leaking – Causes and Solutions
- Too much foam in the dishwasher during or after finish of the cycle
- Dishwasher displays error code i30
- Dishwasher emits clicking/ticking noise during cycle
Related Articles
- The auto-cleaning indicator ("Machine Care") lights up on the dishwasher
- Symbols & programmes on your AEG dishwasher
- Dishwasher does not switch on, does not start a cycle, does not automatically open the door at the end of a cycle
- Dishwasher displays error code i23, not draining
- Dishwasher does not beep at the end of the cycle
- Dishwasher is not heating up water
- Dishwasher Leaking – Causes and Solutions
- Too much foam in the dishwasher during or after finish of the cycle
- Dishwasher displays error code i30
- Dishwasher emits clicking/ticking noise during cycle