Water is flowing back into the dishwasher
Issue
- Water is flowing back into the dishwasher. The problem is caused by the drain hose.
Applies to
- Integrated dishwasher
- Freestanding dishwasher
Resolution
1. Ensure that the drain hose has been installed correctly.
Make sure that:
- The length of the drain hose does not exceed 400 cm.
- The drain inlet point must be between 40 and 85 cm.
- The drain hose is not damaged, kinked or twisted.
2. Contact an Authorized Service Center.
If the above advices do not resolve the problem, we recommend requesting a visit by a service engineer.
Note: The multi-tablet function must be enabled after you select a cycle and will not be saved in the memory.
Warning: We do not recommend using the product until the problem has been completely fixed. Unplug the product and do not plug it in again until you are certain that it is OK to do so.
Was this article helpful?
Related Articles
- Integrated built-in dishwasher door stuck closed
- Dishwasher Tablets Do Not Fully Dissolve / Left In the Base
- Dishwasher displays error code I20, C2, F2 or AL6, or beeps twice, not draining
- Dishwasher does not beep at the end of the cycle
- Dishwasher is stuck mid-cycle and won't allow me to select a different programme
- Dishwasher does not / will not start but the power is on
- Dishwasher installation (Sliding door)
- Dishwasher not cleaning properly
- Dishwasher has poor washing results
- How can I order a spare part for my AEG dishwasher?
Spare parts & Accessories
Find original spare parts and accessories for your appliance in our webshop and have them delivered directly to your door.