Dishwasher displays error code i40, i43 or i44
Issue
- Dishwasher displays error code i40, i41, i43 or i44
- Dishwasher emits 4 beeps / 4 flashes
Applies to
- integrated dishwasher
- freestanding dishwasher
Resolution
1. Reset your appliance.
Remove the plug for the dishwasher and plug it in again after app. 5 minutes.
You can also turn off the power using the fuses on the panel/power switch.
2. Check your dishwasher filter and sump (see the instructional video below) for signs of foam/suds & debris
How To Clean Your Dishwasher Filter
- Make sure you clean all the filters
- Clear any foam/suds from the sump
- Plug the appliance back in. Turn on the dishwasher, select a suitable cycle and start it.
- If the cycle starts and operates normally, the problem has been resolved.
If the above steps don't resolve the issue then a service visit by one of our approved service providers is recommended.
Cause
- i40 error message indicates a potentail fault in the pressure sensor and water level control
Was this article helpful?
Related Articles
- Can I use dishwasher salt in my 9000 series washing machine's SoftWater filter?
- Dishwasher displays error code i30
- Symbols & programmes on your AEG dishwasher
- Dishwasher is stuck mid-cycle and won't allow me to select a different programme
- Program not starting and cycle indicator light flashing on dishwasher
- Dishwasher does not switch on, does not start a cycle, does not automatically open the door at the end of a cycle
- Dishwasher does not / will not start but the power is on
- Dishwasher displays error code I20, C2, F2 or AL6, or beeps twice, not draining
- Dishwasher shows d: on in display / DEMO mode deactivation
- Dishwasher displays error code i24, not draining
Spare parts & Accessories
Find original spare parts and accessories for your appliance in our webshop and have them delivered directly to your door.