Dishwasher displays error code i70
Issue
- My dishwasher doesn't heat or displays error code i70
Applies to
- Integrated dishwasher
- Freestanding dishwasher
Resolution
Reset your appliance.
- Remove the plug for the dishwasher
- Check your dishwasher filter and sump ( See below ) for signs of foam/suds & debris
- Making sure you clean all the filters
- Clearing any foam/suds from the sump. Plug it back in. Turn on the dishwasher, select a suitable cycle and start it.
- If the cycle starts and operates normally, the problem has been resolved.
If the above steps don't resolve the issue then a service visit by one of our approved service providers is recommended.
Cause
- Error code i70 - Temperature sensor in the sump is detecting a defect
Was this article helpful?
Related Articles
- How to adjust water hardness level in dishwasher
- Dishwasher not cleaning properly
- Dishwasher starts the cycle with the door open
- Dishwasher does not beep at the end of the cycle
- Dishwasher displays error code i10, i11, AL5, C1, beeps once, or the warning light flashes once
- Dishwasher is not heating up water
- Dishwasher leaves white residue on dishes and cutlery
- The auto-cleaning indicator ("Machine Care") lights up on the dishwasher
- Dishwasher displays error code i30
- Dishwasher displays error code i60 / i61 / i69 / i6C