Clothes are too creased after drying in tumble dryer
Issue
- Clothes are too creased after drying in tumble dryer
- Tumble dryer heats up too much
Applies to
- Condenser dryer
- Heat pump dryer
Resolution
1. Choose a suitable drying program.
Use a time program, do not dry too long.
Check your user manual for information about the drying time required for different types of laundry.
Download user manual
2. Remove the laundry immediately after the end of the programme.
If necessary extend the crease protection phase or use the start time delay (if available).
Note: Wool and duvet programmes have no anti-crease protection.
3. Do not exceed the maximum load stated in programmes chapter or shown on the display.
Was this article helpful?
Related Articles
- Tumble dryer displays error message E60 and does not heat up
- Tumble dryer displays error code ECA
- Clothes are still wet at the end of the drying cycle
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Cleaning tumble dryer filters and condenser
- Tumble dryer displays error message E40
- Tumble dryer displays error message EHO, EH0
- Tumble dryer's drying results are poor and laundry is damp after drying
- Tumble dryer emits a louder noise during wool cycle
- Tumble dryer displays error message "Err"