Tumble dryer displays error code E9E
Issue
- Tumble dryer displays error code E9E
Applies to
- Tumble dryers
Resolution
- Check main power supply, switch off other running appliances if necessary
- The appliance is probably placed in a small closed storage room and is overheating or the air is heavy with moisture due to the lack of ventilation. Make sure that the appliance is installed in an environment with sufficient air exchange
- Clean the fluff filter and the heat exchanger area. Clean the filter after each drying cycle. Refer to the article: Cleaning tumble dryer filters and condenser
Cause
- Electrical noise
- Humidity/water on UI board
Was this article helpful?
Related Articles
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer displays error message CD
- How to change the dryer door opening directions?
- Tumble dryer emits a louder noise during wool cycle
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Drying Temperature in Heat Pump Tumble Dryer
- Heat pump tumble dryer clothes do not seem hot enough and taking too long to finish (video)
- Tumble dryer does not start / does not work
- Start - Pause LED flashes on tumble dryer
- Tumble Dryer generates scraping/rubbing noise while drum rotating
Spare parts & Accessories
Find original spare parts and accessories for your appliance in our webshop and have them delivered directly to your door.