Tumble Dryer displays error code E50 - Causes and Solutions

Issue

If the E50 error code appears on your tumble dryer display, if the drying programme stops unexpectedly, or if the drum is not rotating correctly, the issue may be caused by an overloaded drum or a problem with the tumble dryer's motor system.

Typical signs:

• E50 or E5E is displayed on the control panel
• An error code beginning with E5 appears
• The drying programme stops before completion
• The drum rotates irregularly or does not rotate
• The tumble dryer does not start the selected programme

Applies to

• Condenser dryer
• Heat pump dryer

Resolution

Start by checking the most common causes of the problem. In many cases, the issue can be resolved without service.

1. Open the tumble dryer door and check whether the drum is overloaded.
2. Ensure that items of laundry have not become trapped inside the drum.
3. Remove some laundry if the load exceeds the maximum capacity recommended for the selected programme.
4. Close the door and start the programme again.
5. If the error code remains, reset the tumble dryer:
   • Disconnect the power supply by unplugging the appliance or switching off the circuit breaker.
   • Wait approximately 1 minute.
   • Restore the power supply.
   • Turn on the tumble dryer and select a programme.
6. Check whether the error code has cleared.

Important

The E50 error code may indicate a temporary motor overload caused by an excessively large laundry load. If the error continues to appear despite correct loading, further inspection may be required.

When Is It a Genuine Fault?

In these situations, there may be a fault with the motor or drive system:

• The E50 error code appears every time the tumble dryer is used
• The drum does not rotate despite a normal laundry load
• The error remains after performing a reset
• The programme stops immediately after starting
• Unusual noises can be heard from the drive system

Book Service

If your tumble dryer continues to experience problems, our specially trained technicians can quickly identify the cause and help resolve the issue.

Whether your appliance is in or out of warranty, we're here to guide you to the right repair solution.

Book a repair online

Cause

FAQ – E50 Error Code on a Tumble Dryer

What does the E50 error code mean on an Electrolux tumble dryer?

The code typically indicates a motor-related issue or an overloaded drum.

Can overloading the tumble dryer cause an E50 error?

Yes. Excessive laundry loads can place additional strain on the motor and trigger the error code.

How do I reset my tumble dryer after an E50 error?

Disconnect the power supply for approximately 1 minute and then reconnect it.

Can I continue using the tumble dryer after the E50 error appears?

Yes, if the error clears after reducing the load or resetting the appliance.

Does the E50 error always indicate a fault?

No. In many cases, it is caused by temporary overload conditions rather than component failure.

When should I contact service?

If the error code returns repeatedly after the load has been adjusted and the tumble dryer has been reset.