Tumble dryer displays error message E80
Issue
- Tumble dryer displays error message E80. It indicates a problem with the cycle selector or the software
Applies to
- Condenser dryer
- Heat pump dryer
Resolution
1. Make sure the cycle selector is not set between two programme options.
2. Reset the appliance.
- Remove the plug from the socket, wait 30 seconds and then plug it in again (The same result may be achieved by using the safety switch).
- After plugging in the appliance, switch it on and select a program.
3. Contact an Authorized Service Center.
If the above suggestions did not solve the problem, we recommend requesting a visit by a service engineer.
Was this article helpful?
Related Articles
- How long does a full load dry to dry take in a dryer - heatpump vs condenser?
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer does not start / does not work
- Tumble dryer's drying cycle does not end / Does not sense when clothes are dry
- Condenser Dryer Drain Kit
- Tumble dryer's drying results are poor and laundry is damp after drying
- Excessive moisture in room, on walls and windows where the tumble dryer is located
- Clothes are still wet at the end of the drying cycle
- Tumble dryer displays error message "Err"
- Tumble dryer emits a louder noise during wool cycle