Tumble Dryer generates scraping/rubbing noise while drum rotating
Issue
- The Tumble Dryer generates scraping/rubbing noise while the drum rotating
- Rear drum locks have not been released correctly during the first use of the dryer
Applies to
- Heat pump dryers
Resolution
The rear drum locks are supposed to be removed automatically when the dryer is activated for the first time without the load in the drum. Please see the dedicated section in the .
However, if something goes wrong you can easily unblock the drum by yourself.
To do so, please follow the steps below:
1. Go to the back of the dryer
2. Find two rear drum locks - white plastic screw heads (hexagon socket) with indicators on them
3. Find the “open padlock” pictogram located close to each of the drum locks
The pictograms are placed on the rear panel
4. Rotate the drum lock to have the indicator near the “open padlock” pictogram
You can rotate the drum locks with a hex key (Allen key) size 12mm or use any other equipment you have at home that makes the screw heads (hexagon socket) possible to rotate
Was this article helpful?
Related Articles
- Clothes are still wet at the end of the drying cycle
- Wool clothes have shrunk after the drying cycle
- How long does a full load dry to dry take in a dryer - heatpump vs condenser?
- Cleaning tumble dryer filters and condenser
- Twisted Laces in the Dryer
- Tumble dryer not drying, not drying properly, too long drying
- Tumble dryer's drying results are poor and laundry is damp after drying
- Before using your AEG tumble dryer for the first time
- Tumble dryer displays error message "Err"
- Condenser Dryer Drain Kit